Phone Setup Options

 

The settings that you can change on a phone fall into several categories, as shown in the following table. For a detailed explanation of each setting and instructions for changing them, see Network Configuration Menu.

 

Note  There are several options on the Network Configuration menu and on the Device Configuration Menu that are for display only or that you can configure from Cisco Unified Communications Manager. These options are also described in this chapter.

 

Settings Configurable from the Phone



Category


Description


Network Configuration Menu Option


General Network Settings


VLAN settings


Admin. VLAN ID allows you to  change the administrative VLAN  used by the phone. PC VLAN allows  the phone to interoperate with  third-party switches that do not  support a voice VLAN.


Admin. VLAN ID  PC VLAN


Port settings


Allows you to set the speed and  duplex of the network and access ports.


SW Port Configuration


IPv4 Network Settings


DHCP settings
 


Dynamic Host Configuration DHCP  Protocol (DHCP) automatically  assigns IP address to devices when  you connect them to the network.  Cisco Unified IP Phones enable  DHCP by default.
 


DHCP
 


DHCP Address Released


IP settings
 


If you do not use DHCP in your network, you can make IP settings  manually.
 


Domain Name
 


IP Address


Subnet Mask


Default Router 1-5


DNS Server 1-5


TFTP settings for  TFTP IPv4 servers
 


If you do not use DHCP to direct the phone to a TFTP server, you must  manually assign a TFTP server. You  can also assign an alternative TFTP  server to use instead of the one  assigned by DHCP.

 


Alternate TFTP
 


TFTP Server 1 
                        


TFTP Server 2    


IPv6 Network Settings


DHCP settings
 


Dynamic Host Configuration   Protocol (DHCP) automatically  assigns IP address to devices when  you connect them to the network.  Cisco Unified IP Phones enable  DHCP by default.
 


DHCPv6
 


DHCPv6 Address Released

 


IP settings
 


If you do not use DHCP in your network, you can make IP settings  manually.
 


Domain Name

 


IP Address


Subnet Mask


Default Router 1-5


DNS Server 1-5


TFTP settings for  TFTP IPv4 servers
 


If you do not use DHCP to direct the phone to a TFTP server, you must  manually assign a TFTP server. You  can also assign an alternative TFTP  server to use instead of the one  assigned by DHCP.

 


Alternate TFTP
 


TFTP Server 1


TFTP Server 2 


IPv6 Network Settings


DHCP settings
 


Dynamic Host Configuration   Protocol (DHCP) automatically  assigns IP address to devices when  you connect them to the network.  Cisco Unified IP Phones enable  DHCP by default.

 


DHCPv6
 


DHCPv6 Address Released


IP settings
 


If you do not use DHCP in your network, you can make IP settings  manually.
 


Domain Name

 


IPv6 Address


IPv6 Prefix Length


IPv6 DNS Server 1-2


TFTP settings for  TFTP IPv6 servers  (SCCP phones only)
 


If you do not use DHCP to direct the phone to a TFTP server, you must  manually assign a TFTP server. You  can also assign an alternative TFTP  server to use instead of the one assigned by DHCP. 


IPv6 Alternate TFTP
 


IPv6 TFTP Server 1


IPv6 TFTP Server 2


Display Settings Menu

Unlock and Lock Options

Value Input Guidelines

Network Configuration Menu